Qingdao Daxin Machinery Co Ltd
Email:sales@daxmachinery.com
Whatsapp:+86 15192782747
How to do daily maintenance for Glass Lifter Published By Daxlifter
After turning off the power of the electric chuck, a part of magnetism is still stored on the sleeve and electric chuck, which is called remanence. Therefore, the workpiece is not easy to remove. At this time, it cannot be forced to remove. Just turn the switch to the demagnetization position to change the coil In the direction of the current, when removing a workpiece with a larger bottom area from the electric suction cup, it is not easy to remove the workpiece because of the large adhesion between the remanence and the smooth surface, otherwise the suction cup table surface will be roughened. The table surface of the electric suction cup should be smooth and bright. When grinding, the electric suction cup should be connected to the power supply to make it in working condition. The amount of grinding is as small as possible, and only the surface of the table is light. Don't over-operate to reduce the service life of the electric sucker.
If the electric suction cup is stored for a long time, in order to prevent the piston rod of the hydraulic cylinder from rusting, the working equipment should be placed on the ground; the whole machine should be cleaned and stored in a boring indoor environment; if the conditions are limited, it can only be stored outdoors. Spread a thin layer of butter on the exposed surface of the piston rod of the hydraulic cylinder, remove the negative terminal of the battery, and add an appropriate proportion of antifreeze to the cooling water according to the lowest temperature. The electric suction cup travel oil pump is a two-way variable plunger pump and drives the vibrating wheel at the same time And the two-way variable motor of the left and right wheels. Turn the travel speed selection switch to select the travel speed range of the roller, and each speed range can operate the travel lever to achieve stepless speed regulation. The walking rod is also the operating rod of the forward and backward reversing equipment. The electric suction cup can smoothly change the direction of travel, and the operation is very simple.
The cutting quality of the electric suction cup is not safe when dealing with the method:
1. Incision height, if the incision height is prohibited in practice, calibration is required;
2. Maintain the lens, check whether the maintenance lens is clean, and require no water, no oil and no slag spots. Sometimes the maintenance lens will be fogged due to the weather or the air is too cold;
3. Optical center, it is recommended to use a cutting nozzle with a diameter of 1.0 to view the optical center, so that the light spot is small and easy to investigate;
4. Correct the cutting parameters. After checking the above items and there is no problem, then correct the parameters according to the relevant phenomena of the electric sucker.
Post time: Apr-26-2021